Optional Blower Operation; Re-Loading The Insert; Overnight Burn; Normal Operating Sounds - Lopi Revere Owner's Manual

Optional Blower Operation

The blower will turn on once the Insert is up to temperature. This is typically 15 to 30 minutes after
starting the fire. Follow the directions below to alter the blower speed.
Route the power cord in a location where it will not come in contact with the appliance or become hot.
An optional hard-wire kit is available for this blower. Order sku #97200337.
The blower may be used to affect heat output (i.e.: to reduce heat output, turn the blower down).

Re-Loading the Insert

Follow the directions below to minimize smoke spillage while re-loading the insert.
Open the air control all the way (pull it out). Open the bypass (pull it out).
1
Open the door slightly. Let the airflow inside the firebox to stabilize before opening the doors fully.
2
Load wood onto the fire.
3

Overnight Burn

This insert is large enough to accommodate burn times up to eight hours. Follow the steps below to
achieve an overnight burn.
Move the air control to high burn and let the insert become hot (burn for approximately 15 minutes).
1
Load as much wood as possible. Use large pieces if possible.
2
Let the insert burn on high for 15 minutes to keep the insert hot, and then turn the air control to low.
3
In the morning the insert should still be hot, with embers in the coal bed. Stir the coals and load
4
small pieces of wood to re-ignite the fire, if desired.
Differences if chimney height and draft may lower overall burn times.

Normal Operating Sounds

© Travis Industries
Operating Your Appliance
OFF
Turn the dial all the
way counter-clockwise
until it clicks off.
Creaks and Clicks:
The 3/16" and 5/16" steel may creak or click when
the stove heats up and cools down - this is normal.
Blower Sounds:
The blower will make a slight "humm" as it
pushes air through the stove.
Hint:
Make sure the leveling bolts on legs are extended -
preventing the hearth from amplifying any vibrations.
HIGH
The high position is all the
way counter-clockwise,
without clicking off.
100-01339
LOW
Turn the dial all
the way
clockwise.
19
4150520