Table of Contents
Advertisement
Adjusting the Flame Height
Your heater has an adjustable flame to tailor the look and heat output to your specific needs. It is
adjusted by turning the middle dial on the valve assembly.
The flame height adjustment
knob is located under the
ashlip behind the access panel
Flame Height
Adjustment Knob
Adjusting the Blower Speed
The blower helps transfer the heat from the heater into the room. It will not turn on until the
heater is up to temperature (approximately 10 minutes after starting). See the illustration below
for instructions on adjusting the blower speed.
ON
OFF
Normal Operating Sounds
Burner Pan
The burner pan is underneath
the logs and is used to mix the
proper amount of air with the
natural gas to produce a clean
and efficient burn. When it is
started you will hear a slight
"whoosh" sound. When the
main burner is running you will
hear the gas flowing through
the burner pan and orifices Ð
this sound will decrease as the
flame height is lowered.
Gas Control Valve
As the gas control valve is
turned on and off you will
hear a dull clicking sound.
This is the valve opening
up and shutting down.
O
PERATING
Turn clockwise to
adjust the flame higher.
Index Mark
OFF
LO
Stove Body
Due to the heavy steel construction,
occasional clicks may come from the
heater, especially during startup.
Y
H
OUR
EATER
H I
Pilot Flame
The pilot flame, which
remains on, makes a very
slight "whisper" sound.
(C
)
ONTINUED
Turn counter-clockwise
to adjust the flame lower.
Turn the knob all the way
counter-clockwise to turn the
blower off. One click
clockwise turns the blower to
high speed. Turning the knob
clockwise from the high
position decreases the speed
of the blower.
Blower
This heater uses a
high tech blower to
push heated air
into the room. It
will make a whirring
sound and will
increase in volume
as the speed is
increased.
Blower Thermodisk
This part can produce a
clicking sound as it turns
the blower on and off.
P
15
AGE
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
