Conversion Kit #502-966 From Lp To Ng - Regency P40-LP Owners & Installation Manual

CONVERSION KIT #502-966 FROM LP TO NG

THIS CONVERSION MUST BE DONE BY A QUALIFIED GAS FITTER
NG Conversion Kit Contains:
Qty. Part # Description
1 910-463 NG Conversion Coil
1 910-036 NG Pilot Orifi ce
1 904-644 Orifi ce #35
1 904-568 Orifi ce #44
1 910-249 J9 Jumper
1 904-529 Allen Key
1 908-514 NG Conversion Decal
1 908-529 NG Yellow Label
1 918-719 Instruction Sheet
1) Turn control knob to the OFF position;
Shut off the gas supply to the valve;
Unplug the power source.
2) Remove the louvers and the fl ush door.
3) Remove the logs.
4) Remove the Steel Fender, by loosening
the retaining srews on both sides and slid-
ing it out of place.
5) Remove the front air box by undoing the 3
screws.
Front Air Box
6) Loosen the air shutter adjustment screw and
pull out the air shutter adjustment wire.
Air Shutter
Air Shutter
Adjustment Screw
Adjustment Wire
Regency ® P40-1 Direct Vent Gas Fireplace
IF IN DOUBT DO NOT DO THIS CONVERSION !!
7) Remove the 2 screws on the back burner.
8) Slide the burner to the right and lift out.
Back Burner
9) Remove the front burner by removing the 2
screws. Lift the burner up and swing to the
right and slide out.
Front Burner
10) Replace the rear burner orifi ce with #35,
using a 1/2" wrench. See image below.
Use another wrench to hold onto the elbow
behind the orifi ce.
11) Replace the front burner orifi ce with #44,
using a 1/2" wrench. See image below.
Use another wrench to hold onto the elbow
behind the orifi ce.
Rear Burner
Orifi ce
INSTALLATION
12) Remove the pilot shield by removing the 2
screws.
Pilot Shield
13) Remove the pilot head from the assembly
using a fl at head screw driver to pop out.
14) Remove the LP pilot orifi ce with the Allen Key
and replace with NG pilot orifi ce. Reattach
pilot head and clip.
Front Burner
Orifi ce
Pilot Head
29