Venting Arrangements; Horizontal Termination (Flex) - Regency P40-LP Owners & Installation Manual

Regency gas fireplace owners and installation manual

Table of Contents

INSTALLATION

These venting systems, in combination with the P40 Direct Vent Gas Fireplace, have been tested and listed as a direct vent heater system by

Warnock Hersey. The location of the termination cap must conform to the requirements in the Vent Terminal Locations diagram in "Exterior Vent

Termination Requirements" section.

Regency

Direct Vent (Flex) System

Termination Kit (Part# 946-618) includes all

the parts needed to install the P40 with a

maximum run of 6 feet.

1) 8" dia. ﬂ exible liner (6 ft. length)

2) 5" dia. ﬂ exible liner (6 ft. length)

3) spring spacers (4)

4) thimble

5) AstroCap XL termination cap (1)

6) screws (12)

7) tube of Mill Pac (1)

8) plated screws (8)

9) screws #8 x 1-1/2" Drill Point,

Stainless Steel (4)

10) vinyl siding standoff

If longer runs are needed, the Regency

Vent system (Flex) Part# 946-616 includes

all the parts needed to install the P40 with a

maximum 10' run.

1) 8" dia. ﬂ exible liner (10 ft. length)

2) 5" dia. ﬂ exible liner (10 ft. length)

3) spring spacers (7)

4) thimble (2)

5) AstroCap XL termination cap (1)

6) screws (12)

7) tube of Mill Pac (1)

8) plated screws (8)

9) screws #8 x 1-1/2" Drill Point,

Stainless Steel (4)

10) vinyl siding standoff

Notes:

1) Liner sections should be continuous without any joints or seams.

2) Only Flex pipe purchased from FPI may be used for Flex installations.

3) Horizontal vent must be supported every 3 feet. (For 10' ﬂ ex kit 946-616 only.)