Table of Contents
Advertisement
INSTALLATION
Read the instructions below carefully and refer to the pictures. If the
logs are broken do not use the unit until they are replaced. Broken
logs can interfere with the pilot operation.
Log kit (Part # 503-930) contains the following pieces:
a)
03-32
Back Log
b)
03-40
Ember Bed
c)
03-34
Front Left Log
d)
03-33
Middle Back Log
e)
03-36
Middle Right Cross Log
f)
03-37
Front Right Log
g)
03-38
Small Ember
h)
03-46
Log Center Left Y
i)
03-47
Log Center Y
j)
902-154
Embers Lava
k)
902-179
Vermiculite
l)
902-153
Rockwool
m)
946-669
Platinum Embers
03-46
03-34
03-32
03-36
1) Carefully remove the logs from the box and unwrap them. The logs
are fragile, handle with care - do not force into position.
2) Remove the brackets on the left and right side of the back air box.
Back Air
Box
32
LOG SET INSTALLATION
(supplied with packaged manual)
03-47
03-37
03-38 (1)
03-33
03-40
03-38 (2)
3) Fit log 03-32 into the pins on the back air box. Push the log tight
against the back brick panel.
4) Re-install the brackets removed in step 2 to hold the log in place.
5) Position log 03-40 up to and against the 2 tabs located on the front
burner. Then slide log 03-40 to the right until it touches the burner
tube.
Front Burner
03-40
Regency
03-32
Burner Tube
®
P40-1 Direct Vent Gas Fireplace
Hide quick links:
Advertisement
Table of Contents
