Brick Panel Installation - Regency P40-LP Owners & Installation Manual

1) Unwrap the Brick Panels from the protective wrapping.
2) Ensure that the logs are not in the unit.
3) Place the 2 small Back Brick Panels at the base of the fi rebox on
the left and right side of the burner assembly.
Note: Ensure that the full brick pattern is on the bottom and the half
brick pattern is on top to line up (approximately) with grout lines on
side brick panels.
Left Side Small
Back Brick Panel
4) Insert the Back Brick Panel by slipping it between the back wall
of the fi rebox and the burner assembly, sitting it on the small back
brick panels installed in step 3.
Back Brick Panel
5) Remove the Top Brick Panel Bracket by removing the 3 screws.
Regency ® P40-1 Direct Vent Gas Fireplace

BRICK PANEL INSTALLATION

Must install 1 set of brick panels with the P40.
6) Place the Top Brick Panel over the back brick panel and secure with
7) Remove the screw on the left side of the fi rebox. Place the left side
Right Side Small
Back Brick Panel
INSTALLATION
the top brick panel bracket.
Top Brick Panel
Bracket
Top Brick Panel
brick panel in position and secure using the brick tab and screw. Repeat
for right side brick panel.
Brick Tab
Brick Panels Completely Installed
IMPORTANT
Dangerous operating conditions may
occur if the panels are broken.
31