Removing The Bake Burner Box - Small Oven - Thermador PRL304EG Service Manual

Service Manual for Thermador Pro Grand LP Gas Ranges, Models: PRL304EG, PRL364EDG, PRL364ELG, PRL366EG, PRL484ECG, PRL486EDG, PRL486EDPG, PRL484ELG
Figure 225: Elbow Connector on Bracket
Figure 226: Orifice on Bracket
58300000156573_ARA_EN_B
4.7.7.5 Removing the Bake Burner Box – Small Oven
Be sure to check QuickFinder for relevant information, documentation,
and correct part numbers when replacing any of these components.
You should be able to access and remove the bake burner, bracket
and orifice assembly without removing the bake burner box. If you
need to lift the burner box out of the cavity for another reason, do the
following:
1. Per respective procedures, make sure the burner has been
removed, wire connections for the HSI and electrode have been
detached, and that the orifice assembly is not in the way.
2. Wearing gloves, push the side frames of the burner box inward
and then pull the burner box out of the cavity. Be careful not to
damage the surrounding insulation that lines the cavity (see
Figure 227).
Figure 227: Cavity for Bake Burner Box (Insulation Shown)
Page 112 of 119