Three-Position Oven Function Selector - Removal And Replacement - Thermador PRL304EG Service Manual

Service Manual for Thermador Pro Grand LP Gas Ranges, Models: PRL304EG, PRL364EDG, PRL364ELG, PRL366EG, PRL484ECG, PRL486EDG, PRL486EDPG, PRL484ELG
1. Follow all safety precautions and steps in Preparing the Range for
Servicing, page 21.
2. Follow all steps in Accessing Components under the Maintop,
page 21.
3. Remove knob from valve stem by slowly pulling knob straight out,
away from control panel.
4. If obstructing access to the Five-Position Oven Function Selector,
remove the burner support rail (with jet holder assemblies
attached) by following the steps in Removing the Burner Support
Rail, page 24.
5. At the back of the control panel, disconnect the plastic multi-pin
connector from the pins on the five-position oven function selector
(see Figure 99).
6. At the front of the control panel, remove and retain the two T-20
screws on the bezel which are attached to the Five-Position Oven
Function Selector (see Figure 100), and then remove the bezel.
Figure 100: Screws on Bezel of Oven Function Selector
7. At the back of the control panel, remove the five-position oven
function selector and replace it if necessary.
58300000156573_ARA_EN_B
4.5.12 Three-Position Oven Function Selector – Removal and
Replacement
The Three-Position Oven Function Selector is for the small oven on
48-inch ranges, as well as on 30-inch and 36-inch ranges.
NOTE: Depending on the range model and FD number, the Three-
Position Oven Function Selector switch may or may not be fastened
with a clip-shaped bracket (see Figure 102).
Be sure to check QuickFinder for relevant information, documentation,
and the correct part number when replacing this component.
Figure 101: Three-Position Oven Function Selector (Typical Models
Shown)
Figure 102: Front and Back of Three-Position Oven Function Selector
(Typical Model Shown with Retaining Bracket)
1 Retaining bracket
Page 53 of 119