Oven Lamp / Lamp Bulb Removal And Replacement; Oven Light Diagnostics - Thermador PRL304EG Service Manual

Pro grand series lp gas ranges
Hide thumbs Also See for PRL304EG:
Table of Contents

Advertisement

Service Manual for Thermador Pro Grand LP Gas Ranges, Models: PRL304EG, PRL364EDG, PRL364ELG, PRL366EG, PRL484ECG, PRL486EDG, PRL486EDPG, PRL484ELG
4.7.2

Oven Lamp / Lamp Bulb Removal and Replacement

Figure 166: Typical Oven Lamp Assembly
1
Wire connectors
2
Bulb
3
Lens (shown removed)
The oven lamp is located inside each oven cavity (see Figure 165).
Access is needed from both the front and back of the range in order to
replace the oven lamp. Replacing the bulb only requires access from
the front of the range.
NOTE: The bulb can be replaced without replacing the lamp
assembly. Refer to the Use and Care manual for the bulb type.
Be sure to check QuickFinder for relevant information, documentation,
and correct part numbers when replacing any of these components.
58300000156573_ARA_EN_B
1. Follow all safety precautions and steps in Preparing the Range for
Servicing, page 21.
2. Remove the backguard (see Backguard and Island Trim Removal
and Replacement, page 73).
3. Remove the back panels (see Back Panel Removal and
Replacement, page 74).
4. Remove oven door (see Oven Door Removal, Installation,
page 88).
NOTE: It is recommended to remove the door, to prevent weight
or force applied from damaging the door and latch components.
5. Remove the oven trays.
6. From the back of the range, detach the lamp wire connectors.
7. From inside the oven cavity, remove and retain the screw that
holds the lamp onto the oven cavity (see Figure 165, page 85).
8. Remove the fixing clip and lens (transparent cover) of the oven
lamp assembly.
9. Replace the bulb if needed.
Fiberglass Insulation
Wear gloves when handling fiberglass insulation.
10. From the back of the range, while wearing gloves, clear a path in
the fiber glass insulation so the lamp wire connectors can be
pulled through the sensor portal.
11. From the front of the range, gently pull the lamp connector wires
through the sensor portal.
12. Replace the lamp if needed.
4.7.2.1

Oven Light Diagnostics

To diagnose problems with the oven light, see Oven Light
Diagnostics, page 86. Also see Oven Lamp Transformer – Removal
and Replacement, page 50.
Page 86 of 119

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents