Bake Burner Components (Small Oven) - Removal & Replacement; Replacing The Bake Burner - Small Oven - Thermador PRL304EG Service Manual

Pro grand series lp gas ranges
Hide thumbs Also See for PRL304EG:
Table of Contents

Advertisement

Service Manual for Thermador Pro Grand LP Gas Ranges, Models: PRL304EG, PRL364EDG, PRL364ELG, PRL366EG, PRL484ECG, PRL486EDG, PRL486EDPG, PRL484ELG
Figure 212: Cavity for Bake Burner Box – Large Oven
1
Insulation in burner box cavity
5. From underneath the burner box, gently pull out the bracket with
orifice and elbow connector attached.
6. Use an adjustable wrench to remove the compression nut at the
elbow connector, and then detach the flex tube from the elbow
connector.
7. While holding the hex nut on the orifice with an adjustable wrench,
rotate the elbow connector to detach the elbow connector and
orifice from the bracket, and then replace the component(s) if
needed.
Gas Leak Testing
With electrical power off, carefully check for gas leaks at each gas
component that was removed, replaced, or otherwise serviced using a
gas leak detector or bubble test.
58300000156573_ARA_EN_B
4.7.7
Bake Burner Components (Small Oven) – Removal &
Replacement
On the 48-inch ranges, both the large and small oven have bake
burners, whose components require access from both the front and
back of the range.
4.7.7.1
Replacing the Bake Burner – Small Oven
Be sure to check QuickFinder for relevant information, documentation,
and the correct part number when replacing this component.
1. Follow all safety precautions and steps in Preparing the Range for
Servicing, page 21.
2. Remove the backguard (see Backguard and Island Trim Removal
and Replacement, page 73).
3. Remove the back panel (see Back Panel Removal and
Replacement, page 74).
4. Remove the crossmember panel (see
5. Remove oven doors (see Oven Door Removal, Installation,
page 88).
6. Remove all the oven racks.
7. Remove and retain the two screws attaching the bottom cover of
the bake burner cavity to the rim of the small oven burner box (see
Figure 213).
Figure 213: Bottom Cover of Bake Burner Cavity – Small Oven
1
Screws (2) on bottom cover of oven cavity
Page 105 of 119

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents