Removal And Replacement Of Top-Accessible Components; Jet Holder Assembly Removal And Replacement - Thermador PRL304EG Service Manual

Pro grand series lp gas ranges
Hide thumbs Also See for PRL304EG:
Table of Contents

Advertisement

Service Manual for Thermador Pro Grand LP Gas Ranges, Models: PRL304EG, PRL364EDG, PRL364ELG, PRL366EG, PRL484ECG, PRL486EDG, PRL486EDPG, PRL484ELG
17. When installing, be sure the orifice is aligned correctly inside the
air shutter section of the grill burner, and that the burner support is
secured properly onto the tab end of the grill burner (Figure 71).
TIP: Correct alignment of the orifice straight into the burner's
Venturi tube maximizes air input for best burner performance.
NOTE: If converting the range for use with LP gas, make sure to
use the orifice provided in the LP conversion kit (PLPKIT).
Figure 71: Orifice—Burner Support—Elbow Connector Assembly
Attached to Air Shutter and Grill Burner Tab
Carefully check for gas leaks at each gas component that was
removed, replaced, or otherwise serviced using a gas leak
detector or bubble test.
58300000156573_ARA_EN_B
4.5 Removal and Replacement of Top-Accessible
Components
This section contains removal and replacement procedures for the
top-accessible components, located under the maintop.
4.5.1

Jet Holder Assembly Removal and Replacement

This procedure is for removing and replacing the jet holder assembly
from the burner support rail. The assembly includes the jet holder, as
well as the orifice (jet) (which is an integral part of the assembly, and
is not available separately).
NOTE: The jet (orifice) should not be removed.
NOTE: If ordering a replacement jet holder assembly, retain the wire
clip for use with the replacement assembly.
Be sure to check QuickFinder for relevant information, documentation,
and the correct part number when replacing this component.
Figure 72: Jet Holder (left) and Wire Guard Clip (Right)
Sharp Components – Gloves Recommended
■ The burner support rail may have sharp edges. Avoid injury by
handling with care.
■ It is recommended to use gloves when removing or installing the
burner support rail.
Page 38 of 119

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents