Dsi Module Removal And Replacement; Led Indicator Removal And Replacement - Thermador PRL304EG Service Manual

Service Manual for Thermador Pro Grand LP Gas Ranges, Models: PRL304EG, PRL364EDG, PRL364ELG, PRL366EG, PRL484ECG, PRL486EDG, PRL486EDPG, PRL484ELG

4.5.20 DSI Module Removal and Replacement

The direct spark ignition (DSI) module is used when the electrode is
the igniter for the bake burner (whether or not the broil burner uses
the HSI or electrode as the igniter).
Be sure to check QuickFinder for relevant information, documentation,
and the correct part number when replacing this component.
Figure 116: DSI Module
1. Follow all safety precautions and steps in Preparing the Range for
Servicing, page 21.
2. Follow all steps in Accessing Components under the Maintop,
page 21.
3. Remove and retain the screws securing the DSI module shield
onto the range chassis, then remove the shield.
4. If obstructing access to the DSI module, remove the burner
support rail (with jet holder assemblies attached) by following the
steps in Removing the Burner Support Rail, page 24.
5. Remove the wire connector.
6. Remove and retain the two screws securing the DSI module onto
the chassis floor.
7. Remove, and then replace the DSI module if needed.
58300000156573_ARA_EN_B

4.5.21 LED Indicator Removal and Replacement

Be sure to check QuickFinder for relevant information, documentation,
and the correct part number when replacing this component.
1. Follow all safety precautions and steps in Preparing the Range for
Servicing, page 21.
2. Follow all steps in Accessing Components under the Maintop,
page 21.
3. If obstructing access to the LED harness, remove the burner
support rail (with jet holder assemblies attached) by following the
steps in Removing the Burner Support Rail, page 24.
4. While holding the two plastic wire connectors, rotate them and pull
to detach (see Figure 117).
5. Push the protruding clip at the front end of the LED indicator while
you simultaneously push the LED indicator frontward through the
hole in the control panel (see Figure 118).
6. Replace the LED indicator if needed.
Figure 117: LED Indicator Wire Connectors
Page 63 of 119