4
LAN Configuration
TCP/IP Parameter Configuration
With Telnet
Whenever a TCP/IP connection to the module is possible (TCP/IP
parameters set by any method), the parameters may be altered by opening
a Telnet session.
1 Open the system (DOS) prompt window by clicking on Windows Start
2 Type the following into the RUN dialog:
If Telnet is not installed on your PC by default, you can turn on the feature via Windows
N O T E
Control Panel.
40
button and select Run....
OR
Press the Windows button and R simultaneously, and click OK.
•
Telnet <IP Address>
•
Telnet <host name> _ this can be set manually.
Figure 5
Starting a Telnet session
where <IP address> may be the assigned address via the instrument,
a configuration session using the web interface of the default IP
address (see
Table 5
on page 35).
Agilent 1290 Infinity II ELSD User Manual