Removing; Adjusting Footrest Height; Model Phwh93 Front Riggings - Invacare Pronto M41 Service Manual

Removing

1. Push the release lever inward and
rotate the front rigging outward.
2. Lift up on front rigging and remove
from the wheelchair.
3. Repeat STEPS 1-2 for opposite side of
wheelchair.

Adjusting Footrest Height

Model PHWH93 Front Riggings

NOTE: For this procedure, refer to FIGURE 7.2.
1. Remove any accessories from the front rigging(s).
2. Remove the front rigging from the wheelchair. Refer to Installing/Removing Front
Riggings on page 44.
3. Lay front rigging on a flat surface to simplify procedure.
4. Remove the hex bolt, coved washers and locknut that secure the footrest to the footrest
support.
5. Reposition the footrest to the desired
height.
6. Reinstall the hex bolt, coved washers
and locknut that secure the footrest to
the footrest support. Tighten securely.
7. Repeat STEPS 1-5 for the opposite side
of the wheelchair footrest if necessary.
8. Reinstall the footrest(s) onto the
wheelchair. Refer to Installing/
Removing Front Riggings on page 44.
Part No 1145724
SECTION 7—FRONT RIGGINGS/FOOTBOARD
Telescoping Front Rigging Support
Hinge
Pins
Release Lever
Hinge
Plate
FIGURE 7.1 Installing/Removing Front
Locknut
Coved
Washer
FIGURE 7.2 Model PHWH93 Front
45
Footplate
Riggings
Footrest Support
Coved Washer
Hex Bolt
Footrest
Riggings
®
Pronto M41