Adjusting The Headrest (Semi-Recline Seat Only); Adjusting Seat Depth - Invacare Pronto M41 Service Manual

Adjusting the Headrest (Semi-Recline Seat Only)

NOTE: For this procedure, refer to FIGURE 6.4.
1. To raise the headrest, lift the headrest up to the desired position.
2. To lower the headrest, push the release tab towards the front of the wheelchair. Lower
the headrest to the desired position.
Release Tab
FIGURE 6.4 Adjusting the Headrest (Semi-Recline Seat Only)

Adjusting Seat Depth

NOTE: For this procedure, refer to FIGURE 6.5 on page 40.
1. Remove the seat. Refer to Removing/Installing the Seat Assembly on page 37.
2. Remove the seat base from the seat assembly. Refer to Adjusting Seat Position on Seat
Base on page 41.
3. Remove the six mounting screws located under the seat that secure the seat back
assembly in place.
4. Adjust seat back assembly to desired position and reinstall the six mounting screws.
Securely tighten.
NOTE: Refer to Detail "A" of FIGURE 6.5 for proper seat depth positions. For example, to achieve
maximum seat depth, the front mounting hole on the seat back bracket aligns with the third hole
on the seat base.
5. Install the seat base onto the seat assembly. Refer to Adjusting Seat Position on Seat
Base on page 41.
6. Reinstall the seat. Refer to Removing/Installing the Seat Assembly on page 37.
Part No 1145724
Headrest
Tube
39
SECTION 6—SEAT
Headrest
®
Pronto M41