Grounding Instructions; Operation Information - Invacare Pronto M41 Service Manual

Grounding Instructions

DO NOT, under any circumstances, cut or remove the round grounding prong from
any plug used with or for Invacare products. Some devices are equipped with three-
prong (grounding) plugs for protection against possible shock hazards and fire.
Where a two-prong wall receptacle is encountered, it is the personal responsibility
and obligation of the customer to contact a qualified electrician and have the two-
prong receptacle replaced with a properly grounded three-prong wall receptacle in
accordance with the National Electrical Code. If you MUST use an extension cord,
use only a three-wire extension cord having the same or higher electrical rating as
the device being connected. In addition, Invacare has placed RED/ORANGE warning
tags on some equipment. DO NOT remove these tags.

Operation Information

Risk of Death, Serious Injury, or Damage
Continued use of the wheelchair that is not set to the correct specifications may
cause erratic behavior of the wheelchair resulting in death, serious injury, or
damage.
Performance adjustments should only be made by professionals of the healthcare
field or persons fully conversant with this process and the driver's capabilities.
After the wheelchair has been set up/adjusted, check to make sure that the
wheelchair performs to the specifications entered during the set up procedure. If
the wheelchair does not perform to specifications, turn the wheelchair Off
immediately and reenter set up specifications. Contact Invacare, if wheelchair still
does not perform to correct specifications.
Risk of Serious Injury or Damage
Moving the seating system from the factory setting may reduce driver control,
wheelchair stability, traction and increase caster wear resulting in serious injury or
damage.
Move the seating system ONLY when necessary to fit the wheelchair to the user.
If the seating system must be moved, ALWAYS inspect the wheelchair to ensure
the front rigging DOES NOT interfere with the front casters.
If the seating system must be moved, ALWAYS inspect to ensure the wheelchair
DOES NOT easily tip forward or backward.
Part No 1145724
SECTION 1—GENERAL GUIDELINES
WARNING
DANGER
WARNING
11 ®
Pronto M41