Table of Contents
Advertisement
Message
Invalid WAN IP Address.
Invalid Gatekeeper Address.
Failed to save data.
Invalid Operation. Initial
setting is not completed.
Network error has occurred.
Check the network. (LANn)
Note
•
The LAN number (1 or
2) is displayed where
"n" is.
System Error! Please restart
the system. If error message
appears again, please
contact Installer or Service
Administrator. * System may
restart automatically.
Failed to obtain the WAN IP
Address.
Document Version 2018-01
•
The format of the router's WAN IP address that you entered is invalid.
→
Enter the WAN IP address correctly, in the format XXX.XXX.XXX.XXX
(decimal values separated by periods). For values of only 1 or 2 digits,
enter these numbers as they are. Do not enter like [.001].
Example: The IP address is [192.168.0.1].
–
Correct entry: [192.168.0.1]
–
Wrong entry: [192.168.000.001]
Multicast or broadcast addresses cannot be used.
•
The format of the gatekeeper's IP address that you entered is invalid.
→
Enter the gatekeeper address for IPv4 addresses correctly. Enter the
gatekeeper address as XXX.XXX.XXX.XXX (values separated by
decimals). For values of only 1 or 2 digits, enter these numbers as they
are. Do not enter like [.001].
Example: The IP address is [192.168.0.1].
–
Correct entry: [192.168.0.1]
–
Wrong entry: [192.168.000.001]
Multicast or broadcast addresses cannot be used.
→
Enter a valid IPv6 address. For the IPv6 address input format, refer to
Page 47.
•
You are using a USB memory device that is not compatible with the
unit.
→
Use a USB memory device compatible with the unit (Page 156).
•
There is not enough free space on the USB memory device you are
using.
→
Confirm the USB memory device has sufficient free space (at least
50 MB) before using it.
•
In local site settings, you tried to select and save a connection mode
without completing network settings.
→
Before making local site settings, change the connection mode
(Page 142) and make network settings (Page 118).
•
A problem has occurred on the network such as a network loop.
→
Check the LAN cables and network equipment. If it has been detected
that the network problem has resolved, the following messages are
displayed. In this case press [ENTER].
The network is normal.
Press [ENTER] and restart the system.
•
The unit's internal software failed to start up.
•
The unit failed to write data to the internal flash memory.
→
If the unit does not restart automatically after 20 seconds, restart the
unit by turning off its power, then turning it back on. If the same message
is displayed after resetting the unit, contact your dealer.
•
There was an error in receiving the WAN address from the external
server.
→
Contact your dealer.
Cause and Solution
Additional Information
User Manual
217
Advertisement
Table of Contents
