Table of Contents
Advertisement
"IP Address": Input the IP address of the multicast terminal at the top of the multicast tree.
Note
•
If the value for "IP Address" contains 1 or 2 digit numbers, enter these numbers as they are. Do
not enter values such as ".001".
Example: The IP address is [192.168.0.1].
Correct entry: [192.168.0.1]
Wrong entry: [192.168.000.001]
5.
Use [
][
] to select "Target" and press [ENTER].
•
The multicast target screen is displayed.
Note
•
If no multicast targets with a " " mark displayed are registered in the selection column, the multicast
will not begin when [START] is pressed.
•
When "LAN 2" is set to "OFF" (Page 120), or when using a KX-VC1000/KX-VC1300, the LAN
column is not displayed.
•
If [ ] is displayed in a target's LAN column, multicasting will not start when you press [START].
The IP address specified for "IP Address" (Page 177) is an IP address of a network that the target
cannot communicate with. Confirm the target's IP address.
6.
Use [
][
] to select the ""Not Registered"" target with the lowest node ID, and then press [B].
•
A dialogue box is displayed for selecting the input method.
When "Input Address" is selected
•
The address input screen is displayed.
Use [
][
"Multicast Target Name": Input the multicast target name (maximum 24 characters) (Page 190).
"IP Address": Enter the IP address.
Document Version 2018-01
] to select the following items for input:
Using Multicast
User Manual
177
Advertisement
Table of Contents
