Belt Drive Issues; Applies To; Issues - Precor SPINNER RALLY Service Manual

Belt Drive Issues

Applies To

All belt drive spinner series bikes.

Issues

Issues related to the belt drive bikes:
ISSUE
Excessive belt
noise.
Pedal slips
when pedaling
with power.
Belt comes off
pulley
See Also
"Troubleshooting" on page 57
CAUSE
Belt tension out-
l
of-spec.
Worn belt.
l
Loose belt, ten-
l
sion out-of-spec.
Worn belt.
l
Loose belt.
l
Misaligned belt
l
pulley alignment.
SOLUTION
Verify and adjust belt tension, see
Tension Adjustment" on
If tension is within spec, inspect belt condition
and replace if worn, see
Replacement" on page 21.
Verify and adjust belt tension, see
Tension Adjustment" on
If tension is within spec, inspect belt condition
and replace if worn, see
Replacement" on page 21.
Verify and adjust belt tension, see
Tension Adjustment" on
Check the front to rear belt pulley alignment. Can-
not be adjusted, check the left/right flywheel axle
bracket condition or possible a bent frame.
"Belt Drive
page 9.
"Belt and Flywheel
"Belt Drive
page 9.
"Belt and Flywheel
"Belt Drive
page 9.
59