Leveling Adjustment Procedure - Precor SPINNER RALLY Service Manual

Leveling Adjustment Procedure

Use this procedure to level the bike. Make sure the bike is level and sits firmly on the floor
before allowing anyone to use the bike.
IMPORTANT: Place the unit on a flat surface. Rotating the adjustable feet does not
compensate for extremely uneven surfaces.
Leveling the bike
1. Tighten all four leveling feet to fully lower the bike.
2. Try to rock the bike. If there is any movement, tip the bike to one side to locate the
adjustable feet.
3. Correct the height of each adjustable foot by turning it clockwise (+) to lower the bike, or
counterclockwise (-) to raise the bike.
4. When you are finished leveling the bike, place it on the floor. Recheck for movement
and readjust as necessary.
See Also
"Adjustment Procedures" on page 8
15