Resistance Issues; Applies To; Issue; Cause - Precor SPINNER RALLY Service Manual

Resistance Issues

Applies To

All Spinner Series Bikes

Issue

Increasing the resistance knob does not apply typical or no increased resistance to the fly-
wheel.

Cause

Most likely the brake pad condition is worn, glazed, and/or dry.
Less likely the resistance knob shaft mechanism has failed.

Solution

Remove the brake pad and visually inspect condition for wear, glazing, and/or dryness of
leather (leather should be moist), replace as necessary, see "Brake Pad Replacement" on
page 24.
If the pad is in good condition, verify that the resistance shaft acorn nut is still attached, and
replace if missing, see "Resistance Knob Replacement" on page 44.
Make sure the resistance knob is moving the shaft up/down when turned. Replace shaft if not
working, see "Resistance Knob Replacement" on page 44.
See Also
"Troubleshooting" on page 57
61