Front Stabilizer Replacement - Precor SPINNER RALLY Service Manual

Front Stabilizer Replacement

About
This procedure provides instruction to remove and install the Front Stabilizer.
Specifications
System Component
Stabilizer fastener Torque
Procedure
Review entire procedure before starting.
Removal Instructions
1. Place a soft mat under the bike frame and stand the bike frame on its back resting on the
rear stabilizer and seat rail.
2. Remove and retain the two stabilizer feet.
3. Remove the front stabilizer by removing the two mounting bolts and washers using a 6
mm hex key. Retain fasteners for installation.
NOTE: The stabilizer attachment bar can slide within the mounting bracket. Make
sure the attachment bar remains in position.
Installation Instructions
2. Position the front stabilizer onto the frame and fasten using the two stabilizer mounting
bolts and washers, torque to 15.6 ft-lbs (21 N•m).
3. Install the two stabilizer feet.
4. Return bike to the upright position.
5. Make sure the bike is level and setting firmly on the floor, see
cedure" on page 15.
6. Verify bike operation per
vice.
Specification
15.6 ft-lbs (21 N•m)
"Operation Verification" on page 7
"Leveling Adjustment Pro-
checklist and return to ser-
53