Table of Contents
Advertisement
Adjust the Belt
Important Improper belt adjustment will cause premature wear and may void the
Precor Limited Warranty.
To adjust the belt:
1.
Loosen the bolt and remove the cover window (Figure 2).
2. Loosen the four bolts holding on the cover and remove it (Figure 4).
3. Remove the four bolts holding on the back cover and remove it (Figure 5).
4. Turn the nut to adjust the belt to between 140-150 pounds of tension
(Figure 6).
Important If the belt is stretched beyond adjustment, replacement of the belt is
recommended.
5. Check that the belt moves smoothly by slowly turning the crank arm while
keeping your fingers away from the belt.
6. Replace the covers.
Replace the Brake Pad
Your bike comes with a spare brake pad. To order more pads, contact Precor Customer Support.
To replace the brake pad:
1.
Remove tension from the brake pad by turning the resistance knob counterclockwise (-) until
completely loose.
2. Using a 5 mm hex key, remove the two bolts holding the brake pad against the frame (Figure 7).
3. Remove the bolt on the brake pad with a 3 mm hex key (Figure 8).
4. Replace the brake pad and secure it with the bolt removed in Step 3.
5. Pull up the resistance knob and slide the new brake pad into place. Secure it using the two bolts
removed in Step 2.
Spinner® Bike Maintenance Guide | P/N 305003-102 rev B, ENU
© 2016 Precor Incorporated | January 2016
Figure 4
Figure 5
Figure 6
Figure 7
Figure 8
4
Advertisement
Table of Contents
