Rear Stabilizer Replacement - Precor SPINNER RALLY Service Manual

Rear Stabilizer Replacement

About
This procedure provides instruction to remove and install the Rear Stabilizer.
Specifications
System Component
Stabilizer fastener Torque
Review entire procedure before starting.
Removal Instructions
1. Place a soft mat under the bike frame and stand the bike frame on its front resting on the
front stabilizer and handlebar
2. Remove and retain the two stabilizer feet.
3. Remove the rear stabilizer by removing the two mounting bolts and washers using a 6
mm hex hey. Retain fasteners for installation.
NOTE: The stabilizer attachment bar can slide within the mounting bracket. Make
sure the attachment bar remains in position.
Installation Instructions
1. Position rear stabilizer onto the frame and fasten using the two stabilizer mounting bolts
and washers, torque to [[[Undefined variable SBK800SpinChrono.Spin-Stab-
ilizerTorque]]].
2. Install the two stabilizer feet.
3. Return bike to upright position.
4. Make sure the bike is level and setting firmly on the floor, see
cedure" on page 15.
5. Verify bike operation per
vice.
Specification
15.6 ft-lbs (21 N•m)
"Operation Verification Checklist" on page 7
"Leveling Adjustment Pro-
and return to ser-
55