Load Laminator Overlay Material - DataCard SD260L Installation And Administrator's Manual

Load Laminator Overlay Material

Load the overlay material in one laminator cartridge at a time.
The L1 (green) and L2 (orange) cartridges fit only in their assigned locations inside
the laminator. They are not interchangeable.
1.
Open the laminator door.
2.
Remove the L1 (green) laminator cartridge
from the laminator. Place the cartridge on a
smooth, level surface for loading.
3.
Push the release latch (a) and open the gate
on the laminator cartridge (b).
A-10 SD460 Laminating System