Description
12) IPv6DNSSecondaryAddress
13) IPv6ManualAddress
14) IPv6ManualPrefixLength
15) IPv6ManualSelect
16) IPv6StatelessAddrSelect
EthAddressMethod—The method used to obtain the IPv4 network IP address. Select DHCP
or STATIC from the Current Value drop-down list.
When the value is DHCP, the EthGatewayAddress, EthIpAddress, and EthSubnetMask
values are controlled by the DNS server and the settings are filled in automatically.
When the value is STATIC, the EthGatewayAddress, EthIPAddress, and EthSubnetMask
values must be set manually.
EthGatewayAddress—Enter the gateway address for the Ethernet network.
EthIpAddress—Enter the static IP address for the printer.
EthSubnetMask—Enter the subnet mask for the Ethernet network.
EthDnsAddress1, EthDnsAddress2, EthDnsSearchSuffix—These settings are not used at this
time.
IPMode—Specify the IP mode used by the printer. The printer can support both IPv4 and
IPv6 addressing. You can select from the following
IPv4—The printer uses IPv4 addressing only.
DualStack—The printer can use both IPv4 and IPv6 addressing.
The remaining IPv6 settings become applicable when IPMode is set to DualStack.
IPv6DefaultGateway—Set a default gateway address. This setting is disabled when set to the
default of "::".
IPv6DHCPv6Select—Select whether or not the printer obtains an address and stateful
configuration from a DHCPv6 server. Disable this setting if a DHCPv6 server is not present.
IPv6DNSPrimaryAddress, IPv6DNSSecondaryAddress—These settings are not used at this
time.
SD260L/SD360/SD460 Installation and Administrator's Guide
Current Value
Default Value
(unit)
::
::
::
::
64
64
Disabled
Enabled
Enabled
Disabled
Allowed
Range
[0 – 128]
47