Exceptioncardnumber; Heaterminutestopower - DataCard SD260L Installation And Administrator's Manual

ExceptionCardImpressTemperature—Set the temperature of the impresser punch (in

degrees Celsius).
Increase the value to increase the temperature of the impresser punch.

Decrease the value to decrease the temperature of the impresser punch.

ExceptionCardNumberOfImpresses—Enter the number of impressions to be stamped on the

card. The impresser can stamp up to three impressions in a row on the left, center, or right
part of the card.
HeaterMinutesToPowerSave—Set the number of minutes before the laminator and

impresser heaters are turned off. After the specified number of minutes, the heaters are
allowed to cool down. Using power save requires a warm-up period before the laminator is
ready to laminate cards again. The front panel LCD displays the message Busy Warming up
and a percentage that indicates the status of the heaters.
Hopper 1 Settings
Use the following settings to specify values for cards picked from the input hopper. Set up the
input hopper for the most commonly used card type.
Hopper 1 Debow Settings:
Hopper1DebowDirection—Set the direction of the debow action in the laminator to return

the card to its proper shape after an overlay is applied. A card may become bowed slightly
due to heat from the laminator.
Down—The debow arms in the laminator press down on the card.

Up—The debow arms press up on the card.

Hopper1DebowDistanceDown—Set the amount (distance) to move the debow arms down.

The value is in increments of the debow motor. (This value is used when
Hopper1DebowDirection is set to Down.)
Increase the value to bend the card down more.

Decrease the value to bend the card down less.

Hopper1DebowDistanceUp—Set the amount (distance) to move the debow arms up. The

value is in increments of the debow motor. (This value is used when
Hopper1DebowDirection is set to Up.)
Increase the value to bend the card up more.

Decrease the value to bend the card up less.

70 Printer Manager