Speed Control Buttons
The speed control buttons (tortoise button (
adjust the maximum speed.
1. To adjust the speed, perform one of the following:
• Adjust Speed in 20% Increments (5 Speed Mode) ‐ Press the tortoise button (
or hare button (
bars in the speedometer will light.
• Adjust Speed in Smaller Increments (VSP Mode) ‐ Perform the following steps:
i. Press and hold both the tortoise button (
joystick beeps.
ii. Perform one of the following:
• Press the tortoise button (
speed in 20% increments. The larger bars in the speedometer will light.
• Press and hold the tortoise button (
increase the speed in smaller increments. The smaller bars in the
speedometer will light.
Mode Button
NOTE: The mode button is present on SPJ+ w/ACC joysticks only.
Press the mode button to switch from driving mode to powered seating mode. Refer to
Operating Powered Seating Systems on page 27 to operate the powered seating system.
Joystick
The joystick has proportional drive control, meaning that the further the joystick is
pushed from the upright (neutral) position, the faster the wheelchair or seat moves. Your
top speed, however, is limited by the programmed settings.
To slow the wheelchair to a stop, simply release the joystick. The wheelchair has
automatic speed and direction compensation to minimize corrections.
Charger/Programming Input
The charger/programming input is located at the front of the joystick housing. This
provides easy access for charging the wheelchair batteries. This port also serves as the
Remote Programmer Communication connection. Driving is prevented while the system
is charging.
Service Indicator
The AMBER service indicator will light when an error or fault occurs. Refer to Service
Indicator Light Diagnostics on page 23 for a listing of the flash codes and what they
indicate.
Part No 1143155
SECTION 5—POWERED SEATING OPERATION
) to decrease/increase the speed in 20% increments. The larger
) or hare button (
33
) and hare button (
) and hare button (
) to decrease/increase the
) or hare button (
Formula™CG Powered Seating
) are used to set and
)
) until the
) to decrease/