Section 11-Ventilator Tray; Preparing The Ventilator Tray For Use - Invacare Formula Owner's Operator And Maintenance Manual

Cg powered seating tilt recline elevate tilt/recline
Hide thumbs Also See for Formula:
Table of Contents

Advertisement

SECTION 11—VENTILATOR TRAY
After ANY adjustments, repair or service and before use, make sure all attaching
hardware is tightened securely - otherwise injury or damage may occur.
Before adjusting, repairing or servicing the seating system, ALWAYS turn the
wheelchair power OFF, otherwise, injury or damage may result.
Pinch points exist between seat and base frames. Use caution, otherwise injury may
occur.

Preparing the Ventilator Tray for Use

Maximum weight capacity for the vent tray is 40 lbs ± 20%. DO NOT exceed weight
capacity for vent tray - otherwise, injury or damage may occur.
The POSITIVE (+) RED battery cable MUST connect to the POSITIVE (+) battery
terminal(s)/post(s), otherwise serious damage will occur to the electrical system.
Install protective caps on POSITIVE (+) and NEGATIVE (-) battery terminals.
DO NOT remove fuse or mounting hardware from POSITIVE (+) RED battery
cable mounting screw.
ALWAYS disconnect the ventilator battery harness from the ventilator battery
harness extension before connecting the ventilator battery harness to the
ventilator. Otherwise damage to the product may occur.
This ventilator tray was designed to hold a ventilator that is approximately 13
inches long, 14½ inches wide, and 14 inches high. Use of ventilators larger than the
above specifications may result in damage to the ventilator or stability issues.
Wheelchairs with Recline System Only - Any ventilator installation MUST provide
adequate clearances to allow unobstructed mechanical operation of the seating
system. In addition, some ventilators may have additional clearance requirements.
ALWAYS refer to the ventilator's instructions prior to installation for any
additional requirements.
NOTE: For this procedure, refer to FIGURE 11.1 on page 78.
1. Position straps to the outside of the ventilator tray.
2. Position the ventilator (not shown) on the ventilator tray.
NOTE: Ensure the ventilator battery harness is NOT connected to the ventilator battery before 
performing STEP 3.
3. Connect the ventilator battery harness to the ventilator.
Part No 1143155
SECTION 11—VENTILATOR TRAY
WARNING
WARNING
CAUTION
77
Formula™CG Powered Seating

Advertisement

Table of Contents
loading

Table of Contents