8. Connect the front battery wiring harness from the ventilator connector.
9. Install the rear shroud, front shroud and battery retention bracket. Refer to Removing/
Installing the Wheelchair Shrouds on page 71.
10. Connect the joystick. Refer to Disconnecting/Connecting the Joysticks on page 69.
NOTE: Battery tray
shown removed for
clarity.
FIGURE 10.3 Installing/Removing the Batteries (TDX SP with Vent Tray Option)
Disconnecting/Connecting the Joysticks
NOTE: For this procedure, refer to FIGURE 10.4 on page 70.
NOTE: The joystick connector is located at the rear of the seat frame.
SPJ+ Joysticks
Disconnecting
1. Hold the light GREY collar portion of the joystick connector with one hand and the
controller connector on the wheelchair in the other and disconnect them by pulling
them apart.
Connecting
The joystick connector and controller connector fit together in one way only; DO
NOT force them together.
1. Hold the light GREY collar portion of the joystick connector with one hand and the
controller connector on the wheelchair in the other and align them.
2. Lightly push to engage the joystick connector and the controller connector.
Part No 1143155
FRONT OF
WHEELCHAIR
Right Battery
Disconnect the Right Battery
from the Left Battery Here
WARNING
69
SECTION 10—BATTERIES
Disconnect Battery Harness
from the Controller
Connector Here
Left Battery
Disconnect Front Battery
Harness from the Ventilator
Connector Here
Front Battery
Battery Straps
Battery Tray
Formula™CG Powered Seating