Use The Bolt-Down Openings - DataCard CR825 Installation And Administrator's Manual

Use the Bolt-Down Openings

The printer includes bolt-down openings that you can use to secure it to a mounting surface.
You need the following supplies:
The bolt-down kit (part no. 512969-001) contains two M6 well nuts.

Two M6 (6 mm) screws, purchased separately.

The length of the screws you need depends on the thickness of the mounting surface. The
screw length is the surface thickness + 0.75 inch (20 mm).
Two M6 washers, purchased separately.

1/4-inch (7 mm) drill bit.

1.
Drill two holes in the mounting surface following the dimensions and requirements shown in
the following figure:
10 Printer Installation