Table of Contents
Advertisement
Remove Shipping Items
The embosser is shipped with inserts that secure internal components during transport. Remove
these items before proceeding with setup.
1.
Unlock and open the embosser supplies access door.
2.
Remove the indent ribbon and topping foil cartridges.
3.
Remove the foam "T" and block inserts used to secure the topping and transport
mechanisms during shipping. Save the inserts in case you need to repack the embosser for
transport.
4.
If you plan to secure the embosser to a worktable, continue with
Secure the Embosser
This procedure is optional. Contact your system administrator for requirements.
You can secure the embosser using one of the following:
The bolt-down openings in the bottom of the embosser enclosure
An optional cable lock
CR825 and CE875 Instant Issuance System Installation and Administrator's Guide
"Secure the
Embosser".
A-7
Advertisement
Table of Contents
