Server Warnings And Cautions - HP ProLiant XL270d Gen9 Maintenance And Service Manual

Server warnings and cautions

WARNING:
This server is very heavy. To reduce the risk of personal injury or damage to the equipment:
• Observe local occupational health and safety requirements and guidelines for manual handling.
• Reduce the weight of the server by removing the drives before installing or removing the server
from the chassis.
• Obtain adequate assistance to lift and stabilize the server during installation or removal. Hewlett
Packard Enterprise recommends that a minimum of two people are required for installing or
removing the server from the chassis. A third person might be required to help align the server if
the server is installed higher than chest level.
• Use caution when installing or removing the server from the chassis; it is unstable when the
server locks are not engaged with the chassis.
WARNING:
To reduce the risk of personal injury from hot surfaces, allow the drives and the internal system
components to cool before touching them.
CAUTION:
Electrostatic discharge can damage electronic components. Be sure you are properly grounded
before beginning this procedure.
28 Server warnings and cautions
This symbol on an RJ-45 receptacle indicates a network interface connection.
WARNING: To reduce the risk of electric shock, fire, or damage to the equipment, do
not plug telephone or telecommunications connectors into this receptacle.
This symbol indicates the presence of a hot surface or hot component. If this surface is
contacted, the potential for injury exists.
WARNING: To reduce the risk of injury from a hot component, allow the surface to cool
before touching.
This symbol indicates that the component exceeds the recommended weight for one
individual to handle safely.
WARNING: To reduce the risk of personal injury or damage to the equipment,
observe local occupational health and safety requirements and guidelines for manual
material handling.
These symbols, on power supplies or systems, indicate that the equipment is supplied
by multiple sources of power.
WARNING: To reduce the risk of injury from electric shock, remove all power cords to
disconnect power from the system completely.