Outputs And Inputs; Cursor And Cursor Movement; Planning - Siemens Logo! Manual

Rule 2

Outputs and inputs

S
Always create your circuit program by working from the
output to the input.
S
You can connect an output to several inputs, but not the
same input to several outputs.
S
Within the same program path you may not connect an
output to an upstream input. For such internal recur-
sions you should interconnect flags or outputs.
Rule 3

Cursor and cursor movement

The following applies when you edit a circuit program:
S
You can move the cursor when it appears in the form
of an underscore:
– Press , , or
– Press OK to change to "Select connector/block"
– Press ESC to exit programming mode.
S
You select a connector/block
S
when the cursor appears as solid square
– Press or
– Confirm with OK.
– Press ESC to return to the previous step.
Rule 4

Planning

S
Before you start to create a circuit program, you should
either first create design on paper or program LOGO!
directly using LOGO!Soft Comfort.
S
LOGO! can only save complete and faultless circuit pro-
grams.
LOGO! Manual
A5E00380835-01
program.
to select a connector or a block.
Programming LOGO!
to move the cursor in the circuit
67