Parameter Inputs; Time Response; Parameter T - Siemens Logo! Manual

LOGO! functions

Parameter inputs

At some of the inputs you do not apply any signals. You
configure the relevant block values instead. Examples:
S
Par (Parameter):
This input will not be connected. Here, you set the rele-
vant block parameters (times, on/off thresholds etc.).
S
No (Cam):
This input will not be connected. Here, you configure the
time patterns.
S
P (Priority):
This is an open input. Here, you define priorities and
specify whether a message is to be acknowledged in
RUN.
4.3.2

Time response

Parameter T

At some of the SFs it is possible to configure a time value
T. When you preset this time, note that your input values
are based on the timebase set:
Timebase
s (seconds)
m (minutes)
h (hours)
B1
T
Note
Always specify a time T in w 0.02 s. The time T is not de-
fined for T t0.02 s.
126
+
=04:10h
_ _ : _ _
1
seconds :
minutes : seconds
hours : minutes
Setting a time T of 250 minutes:
Unit in hours h:
04:00 hours
00:10 hours
=
/ seconds
100
240 minutes
+10 minutes
250 minutes
LOGO! Manual
A5E00380835-01