Verification Of The Circuit Program - Siemens Logo! Manual

Programming LOGO!
The display now shows:
B2
T=12:00m
Retentivity R: Current
data are retained
3. Confirm your entries with
Note
For further information on the protection mode, refer to
Chapter 4.3.5.
For further information on retentivity,
refer to Chapter 4.3.4.
You can modify the protection mode and retentivity setting
only in programming mode, i.e. this is not possible in pa-
rameter assignment mode.
In this manual, the protection mode ("+" or "–") and reten-
tivity ("R" or "/") settings are only shown in the displays
where these can actually be changed.

Verification of the circuit program

This program branch for Q1 is now completed. LOGO!
shows you the output Q1. You can once again view the cir-
cuit program on the display. Use the keys to browse the
circuit program, i.e. press
block,
92
–R
and to move between the inputs at a block.
B2
T=12:00m
or
Retentivity /: Current
data are not retained
OK
or to move from block to
–/
LOGO! Manual
A5E00380835-01