Connecting The Logo! To A Pc; Connecting The Pc Cable; Connecting The Pc Cable To The Usb Port; Switching Logo! To Pc´logo Mode - Siemens Logo! Manual

LOGO! Software

7.1 Connecting the LOGO! to a PC

Connecting the PC cable

To connect the LOGO! to a PC, you need the LOGO! PC
cable (order number is found in Appendix E).
Remove the cap or program module (card) from your
LOGO! and connect the cable to this socket. Connect the
other end of the cable to the serial port of your PC.

Connecting the PC cable to the USB port

If your PC is only equipped with a USB interface (Universal
Serial Bus), you will need a converter and a device driver to
connect the LOGO! cable to this port. Follow the instruc-
tions on the screen when you install the driver for the
converter. Make sure you specify the correct Windows OS
version when you select the driver.
We have had good results using Keyspan's USA-19QW
USB converter as well as the GMUS-03 one available from
the Kabelshop online shop. You can find these suppliers on
the Internet at http://www.keyspan.com or www.kabels-
hop.net respectively.
Switching LOGO! to PC´LOGO mode
1. Switch the LOGO! with/without display to STOP from
your PC (refer to the LOGO!Soft Comfort Online Help),
or select the ESC / >Stop command on a device with
display and confirm the entry with 'Yes'.
When LOGO! is in STOP and online with the PC, the fol-
lowing PC commands are accepted:
S
Switch LOGO! to RUN
S
Read/write the circuit program
S
Read/write the summertime/wintertime
260
LOGO! Manual
A5E00380835-01