To Copy The Circuit Program To The Program Module (Card) - Siemens Logo! Manual

LOGO! program module (card)
6.3 Copying data from the LOGO! to the pro-
gram module (card)

To copy the circuit program to the program module (card):

1. Insert the program module (card) into the slot.
2. Switch the LOGO! to programming mode (ESC / >Stop).
>Program..
Card..
Setup..
Start
3. The main menu opens. To select the 'Card' command:
4. Press OK. The transfer menu opens.
>
Card"
CopyProtect
5. Move the '>' cursor to 'LOGO ³ Card' (if required)
6. Press OK.
LOGO! now copies the circuit program to the program mod-
ule (card).
When LOGO! has finished copying, it automatically returns
you to the main menu:
>Program..
Card..
Setup..
Start
The circuit program backup is now stored on your program
module (card) and you can remove the card. Do not forget
to replace the cap.
252
"Card
LOGO! main menu
Press or
= LOGO!
Press or
LOGO! Manual
A5E00380835-01