YASKAWA A1000 Quick Start Manual page 16

3 Electrical Installation
Power Supply Side Cable Connections
The way the drive is connected to the mains depends on the optional components installed on the input side. Refer to the
table below for terminal labelling, screw sizes and torque values.
Input
Direct Connection to Drive
Terminal Screw Size
Torque (Nm)
Identification
Connection to Mains Switch (Rotary)
Terminal Screw Size
Torque (Nm)
Identification
Connection to Circuit Breaker
Terminal Screw Size
Torque (Nm)
Identification
Connection to Standard EMC Filter
Terminal Screw Size
Torque (Nm)
Identification
Connection to IT Grid EMC Filter
Terminal Screw Size
Torque (Nm)
Identification
Connection to Mains Fuses
Stud Size
Torque (Nm)
If the drive is not equipped with a circuit breaker or mains fuses, make sure to apply adequate branch circuit protection.
Use fuses recommended below:
Main Fuse
Manufacturer: Bussmann
Door Fan supply
For proper cooling of the unit make sure to always connect 230 V AC single-phase power supply to the door fan. The
door fan is temperature controlled and will only run if the panel inside temperature exceeds the threshold value.
Door Fan Supply (DIN Rail)
Cable Size (mm²)
Terminal Screw Size
Torque (Nm)
Identification
EN 16
0208 0250
M10
20
L1, L2, L3
L1, L2, L3
L1, L2, L3: M8
PE: M12
L1, L2, L3: 10
PE: 32
L1, L2, L3: Cage Clamp,
max. 150 mm²
L1, L2, L3: 10
PE: 32
16
0208 0250
FWH-500A FWH-600A FWH-700A
YASKAWA Europe TOEP C710616 88A - AC Drive A1000 IP23/54 Floor Standing - Quick Start Guide
Model A14
0296 0362
R/L1, S/L2, T/L3
M10
20
M10
20
L1, L2, L3: M10
L1, L2, L3: 20
L1, L2, L3
L1, L2, L3: 20
L1, L2, L3
M10
20
Model A14
0296 0362
FWH-800A
All Models
1.5
M4
1
L, N, PE
0414 0515
M12
32
Busbar, L1, L2, L3
Busbar, L1, L2, L3
PE: M12
PE: 32
M12
PE: 32
M12
40
0414 0515
FWH-1000A FWH-1200A
0675
2× M10
2× M10
0675