Programming The Base And Offset Frequencies - Radio Shack PRO-94 Owner's Manual

Note: If you select size code S-12, S-13, or S-14, these
restrictions apply:
• S-12 can only be assigned to Blocks 0, 2, 4, or 6
• S-13 can only be assigned to Blocks 0 and 4
• S-14 can only be assigned to Block 0
Since these size codes require multiple blocks, you will
be prompted for the next available block when you pro-
gram a fleet map. For example, if you assign Block 0 as
S-12, the scanner prompts you for
available, instead of b1. If you assign Block 0 as S-14,
you would not see another prompt because S-14 uses
all available blocks.
Programming the Base and
Offset Frequencies
To properly track Motorola VHF and UHF trunked sys-
tems, you must program the applicable base and offset
frequencies for each system.
For a list of these frequencies and other scanner infor-
mation, go to www.trunkscanner.com and other similar
frequency resources.
1. Set the scanner for conventional scanning. Press
then
PROG
2. Press the number key of the bank where you want
to store the base frequency.
3. Repeatedly press
, then press
E2-UHF
trunked frequency appears.
4. Press
DATA (ALT)
appears.
5. Enter a desired frequency.
6. Press
DATA (ALT)
appears.
56
.
TRUNK
8 8 8 8
or
. A previously programmed
E
. The preset base frequency
. The preset offset frequency
Trunking Operation
, the next block
b2
9 9 9 9
to select or
E2-VHi