Resetting The Scanner - Radio Shack PRO-94 Owner's Manual

1000-channel handheld trunking scanner
Hide thumbs Also See for PRO-94:
Table of Contents

Advertisement

Problem
Missing replies to
conversations.
Channel activity
bars are flashing
but no sound is
heard.

RESETTING THE SCANNER

If the scanner's display locks up or stops operating prop-
erly, you might need to reset the scanner.
Caution: This procedure clears all the information you
have stored in the scanner. Before you reset the scan-
ner, try turning it off and on to see if it begins working
properly. Reset the scanner only when you are sure it is
not working properly.
68
Possible Cause
The system you
are trying to track
is a Type I sys-
tem, and the
scanner is set to
scan Type II sys-
tems.
The selected
fleet map is incor-
rect.
Not all of the
trunk's frequen-
cies have been
entered.
The transmis-
sion might be a
private or tele-
phone intercon-
nect call. The
scanner does not
scan these types
of transmissions.
The ID shown is
not active.
Troubleshooting
Remedy
Set the scanner to
receive Type I
trunked frequen-
cies. See "Scanning
Type I and Hybrid
Trunked Systems"
on Page 51.
Try another preset
fleet map or pro-
gram your own fleet
map (see "Scanning
Type I and Hybrid
Trunked Systems"
on Page 51).
Enter all of the
trunk's frequencies
(see "Storing
Trunked Frequen-
cies" on Page 40).
Scan for another
transmission.
Wait for the ID to
become active, or
scan another trans-
mission.

Advertisement

Table of Contents
loading

This manual is also suitable for:

20-524

Table of Contents