Using The Display Backlight; Using The Auto Backlight Display; Changing Search Speeds; Turning The Keytone Off/On - Radio Shack PRO-94 Owner's Manual

USING THE DISPLAY BACKLIGHT

To turn on the display light for easy viewing at night,
press .The display lights for 15 seconds. To turn off
the light sooner, press
USING THE AUTO BACKLIGHT
DISPLAY
You can set the scanner so the auto backlight turns on
for about 5 seconds when the scanner receives signals.
If you press a key (except
display remains lighted for more than 15 seconds.
To turn auto backlight display on or off, turn off the scan-
ner. Then hold down
briefly appears when auto backlight is on.
Aut Lit
briefly appears when auto backlight is off.
Aut Lit

CHANGING SEARCH SPEEDS

Note: Hypersearch applies only to the 5 kHz step bands
(29–54 MHz, 137–174 MHz, and 216–224.9950 MHz).
The scanner has two search speeds.
Normal Search
100 steps/second
To switch between the normal and Hypersearch speeds
during limit search or direct search, press
appears during Hypersearch.

TURNING THE KEYTONE OFF/ON

1. Turn off the scanner.
2. While holding down
OFF bEEP
To turn the key tone back on, repeat these steps.
appears.
bEEP
34
again.
and turn on the scanner.
L-OUT/S/S,
appears.
Special Features
) within 5 seconds, the
Hypersearch
300 steps/second
H/S
turn on the scanner.
on
OFF
.
HYPER
on