Table of Contents
Advertisement
S-14, you would not see another prompt because S-14 uses all available blocks.
programming a hybrid system
A hybrid system is simply a Type I system with some of its blocks designated as Type II
blocks. To program a hybrid system, follow the steps listed in "Programming a Fleet Map."
However, if you want a block to be Type II, instead of pressing
block (Step 6), enter size code S-0 instead.
programming the Base and Offset frequencies
To properly track Motorola VHF and UHF trunked systems, you must program the
applicable base and offset frequencies for each system. For a list of these frequencies and
other scanner information, go to www.trunkscanner.com and other similar frequency
resources.
1. Press FUNC, then press MENU to open menu mode.
2. Select the "Trunk Option" - "Select Bank" - "Select Trunk Sys".
3. Repeatedly press
press ENT/PGM.
4. Repeatedly press
5. Repeatedly press
6. Repeatedly press
7. Use [1] through [9], [0], [.] to enter a Base Frequency, and then press ENT/PGM.
8. Repeatedly press
9. Repeatedly press
• For MOT 800 CUSTOM (Motorola Type I, Type II and Hybrid 800 MHz), use 12.5 kHz or
25kHz steps.
• For MOT VHF (Motorola Type II VHF), use 5 kHz steps between 5 kHz – 100 kHz.
• For MOT UHF (Motorola Type II UHF), use 12.5 kHz steps between 12.5 kHz – 100
kHz.
10. Repeatedly press
11. Use [1] through [9], [0] to enter an Offset Channel, then press ENT/PGM.
Note: You can only input a frequency between 380 – 759 for VHF and UHF trunked system.
You can only input within a range of 0 – 1023 for Custom trunked system.
12. Press CL. The scanner returns to the previous screen. Repeat steps 5 through 10 to
program additional configurations.
turning the Motorola disconnect tone detect function On/Off
When the Motorola disconnect tone detect function is disabled, the scanner looks for
squelch before returning to the control channel instead of waiting for the disconnect tone.
Only in rare instances will you need to adjust the default settings. The condition to return to
control channels depends on whether the signal is present or not.
1. Press FUNC, then press MENU to open menu mode.
2. Select the "Trunk Option" - "Select Bank" - "Select Trunk Sys".
3. Repeatedly press
or
to select MOT 800 CUSTOM, MOT VHF or MOT UHF and
or
to select Edit Band Plan, and press ENT/PGM.
or
to select desired Band Plan, and press ENT/PGM.
or
to select Base Frequency , and press ENT/PGM.
or
to select Spacing, and press ENT/PGM.
or
to select desired spacing frequency, and press ENT/PGM.
or
to select Offset, and press ENT/PGM.
or
to select Motorola system, and press ENT/PGM.
or
to select the size
30
Hide quick links:
Advertisement
Table of Contents
