D-Link DAP-1360 User Manual page 49

DAP-1360 Wireless N300 Access Point & Router
User Manual
Parameter
Mode
Start IP
End IP
Gateway IP address
Primary DNS server/
Secondary DNS server
Lease time
When all needed settings are configured, click the Apply button.
In the Static DHCP section, you can specify MAC address and IP address pairs (set a fixed IP
address in the local area network for a device with a certain MAC address). The
assigns IP addresses in accordance with the specified pairs only when the DHCP server is enabled
(in the DHCP server section, in the Mode drop-down list, the Enable value is selected).
An operating mode of the
Enable: the
access point
automatically in accordance with the specified parameters. When
this value is selected, the Start IP, End IP, Gateway IP address,
Primary DNS server, Secondary DNS server, and the Lease
time fields are displayed on the page.
Disable: the
access
addresses are assigned manually.
The start IP address of the address pool used by the DHCP server to
distribute IP addresses to clients.
The end IP address of the address pool used by the DHCP server to
distribute IP addresses to clients.
The gateway IP address for clients of the access point. When this
field is left blank, clients use the IP address of the access point as the
gateway address.
The IP addresses of the primary and secondary DNS servers for
clients of the access point. When these fields are left blank, clients
use the IP address of the access point as the addresses of the DNS
servers.
The lifetime of IP addresses leased by the DHCP server. At the end
of this period the leased IP address is revoked and can be distributed
to another device, unless the previous device has confirmed the need
to keep the address.
Figure 38. The section for creating MAC-IP pairs.
Page 49 of 270
Configuring Device (Access Point Mode)
Description
access point's DHCP server.
assigns IP addresses to clients
point's DHCP server is disabled, clients' IP
access point