Remote Update - D-Link DAP-1360 User Manual

DAP-1360 Wireless N300 Access Point & Router
User Manual

Remote Update

!
Attention! Do not turn off the access point before the firmware upgrade is completed.
This may cause the device breakdown.
To update the firmware of the access point remotely, follow the next steps:
1. On the System / Firmware upgrade page, in the Remote update section, click the
Check for updates button to check if a newer firmware version exists.
2. Click the OK button in the window displayed to upgrade the firmware of the access point.
Also you can upgrade the firmware of the access point by clicking the Remote update
button (the button is displayed if a newer version of the firmware is available).
3. Wait until the access point is rebooted (about one and a half or two minutes).
4. Log into the web-based interface using the login (admin) and the current password.
After the upgrade is completed, the new version of the firmware will be displayed in the top left
corner of the page.
If after updating the firmware the access point doesn't work correctly, please restore the factory
default settings. To do this, place the mouse pointer over the System caption in the top left corner
of the page and click the (Reset to factory) icon. Wait until the access point is rebooted.
Page 262 of 270
Configuring Device (Router Mode)