Ethernet Communication Parameters (Functions) And Instruction Codes; Under Different Control Methods - Mitsubishi Electric FR-A820-00046 Instruction Manual

Ethernet communication parameters (functions) and instruction codes under different control methods
A.4 Ethernet communication parameters (functions) and
instruction codes under different control methods
The following table shows the Ethernet communication parameters (FR-A800-E only), the corre-
sponding instruction codes, and the availability of the parameters by control method.
Instruction codes are used to read or write parameters through the Ethernet network (Modbus®/
TCP or CC-Link IE Field Network Basic).
(Refer to page 5-786 for the details of the Modbus®/TCP, and to page 5-802 for the details of the
CC-Link IE Field Network Basic.)
Function availability under each control method is shown as below:
: Available
×: Not available
For "parameter copy", "parameter clear", and "all parameter clear", the function availability is
indicated as follows:
: Available
×: Not available
Communication parameters that are not cleared by Parameter clear (All parameter clear) through
the Ethernet network (Modbus®/TCP or CC-Link IE Field Network Basic).
(Refer to page 5-786 for the details of the Modbus®/TCP, and to page 5-802 for the details of the
CC-Link IE Field Network Basic.)
Position control is enabled when an MM-CF IPM motor is used with the low-speed range high-
torque characteristic enabled (Pr. 788 "Low speed range torque characteristic selection" = "9999"
(initial value)).
Pr. Name
Station number in inverter-to-
1124
inverter link
Number of inverters in inverter-
1125
to-inverter link system
Ethernet communication
1424
network number
Ethernet communication station
1425
number
Link speed and duplex mode
1426
selection
1427 Ethernet function selection 1
1428 Ethernet function selection 2
1429 Ethernet function selection 3
Ethernet signal loss detection
1431
function selection
Ethernet communication check
1432
time interval
1434 Ethernet IP address 1
1435 Ethernet IP address 2
1436 Ethernet IP address 3
Tab. A-4: Parameter list with instruction codes for Ethernet communication(1)
A - 40
Instruction code
 
18 98 B
 
19 99 B
 
18 98 E
 
19 99 E
 
1A 9A E
 
1B 9B E
 
1C 9C E
 
1D 9D E
 
1F 9F E
 
20 A0 E
 
22 A2 E
 
23 A3 E
 
24 A4 E
Control method
Vector Vector Vector Sensorless Sensorless Sensorless
    
    
    
    
    
    
    
    
    
    
    
    
    
Appendix
Parameter
PM PM PM
    
    
    
    
    
    
    
    
    
    
    
    
    