Serial S-Record Upgrade Errors; Cannot Upgrade Software; Upgrade Failed; Isdn Upgrade Errors - Lucent Technologies 2300EU System Administrator Manual

Troubleshooting
The Serial S-Record upgrade may encounter problems
Serial
during the upgrade process. Your terminal will display
S-Record
either cannot Upgrade Software or Upgrade Failed
Upgrade
messages explaining why the upgrade failed.
Errors
If the erasing flash process takes longer than 60 seconds a
Cannot
flash error will occur and will require you to power-down
Upgrade
your module (for at least ten seconds). You then need to
Software
retry the upgrade process by re-entering the configuration
menu. If the same result occurs, your flash memory is not
working correctly and you will have to contact Customer
Support. Verify failure with Power-up LED Sequences,
three red LED flash failure.
If the upgrade failed, attempt the download procedure
Upgrade
again. If you encounter consistent failures, consider using
Failed
the ISDN Upgrade procedure or contacting Customer
Support. Refer to Cannot Upgrade Software section.
The following upgrade errors may be displayed if
ISDN
problems occur during the upgrade process. Reattempt
Upgrade
the upgrade if an error occurs. If errors continue, please
Errors
contact Customer Support.
The code is too large for the Switch Module Flash ROM
PBX Flash
and is unable to upgrade your unit with this code release.
Too Small
The code is too large for the Remote Module Flash ROM
REM Flash
is unable to upgrade your unit with this code release.
Too Small
ISDN DEFINITY® Extender 2300EU/2100EU
53