Lucent Technologies 2300EU System Administrator Manual page 46

2100EU AT Command Set
Terminal Adapter Configuration Commands
Command Description
S7= Supported for compatibility with
BitSURFR command lines. The
value of this command is ignored.
S12= Guard Time - The guard time
before the module starts looking
for the escape sequence (see S2=)
&Cn Data Carrier Detect - Sets whether
DCD is always asserted or tracks
the ISDN connection
&Dn Data Terminal Ready - Sets how
the module handles the DTR
signal from the PC
%A2= Select the protocol used on the
ISDN connection
%A95= Accept incoming data calls
%A96= Supported for compatibility with
BitSURFR command lines. The
value of this command is ignored.
&V View TA configuration
@MENU Display the 2100EU/230EU
Extender configuration menu
Table 3. Terminal Adapter Configuration Commands Cont'd
38
Values
1-255
0-63, 255 (default = 50)
The units for this value
are 1/50 of a second
n=0- always on
n=0- ignore DTR
95 - PPP <default>
D - do not answer
E - answer <default>
0 or 1
Continued on the next page...
ISDN DEFINITY® Extender 2300EU/2100EU
cont'd
1- tracks connection
<default>
1- Return to AT
command mode
from online mode
(connection remains
active)
2 – Disconnect the
call and return to AT
command mode
<default>