Genie S-60 HC Operator's Manual page 42

Operator's Manual
Operating Instructions
Drive Enable
Light on indicates that the
boom has moved just past
either non-steer wheel and
drive function has been
interrupted.
To drive, hold the drive enable switch to either side
and slowly move the drive control handle off center.
Be aware that the machine may move in the
opposite direction that the drive and steer controls
are moved.
Always use the color-coded direction arrows on the
platform controls and the drive chassis to identify
the direction the machine will travel.
Engine Idle Select (rpm)
Select engine idle (rpm) using the symbols on the
control panel.
When the foot switch is not pressed, the engine will
idle at the lowest rpm.
· Turtle symbol: Foot switch activated low idle
· Rabbit symbol: Foot switch activated high idle
Drive Speed Select
· Machine on incline symbol: Low range operation
for inclines
· Machine on level surface symbol: High range
operation for maximum drive speed
40
Generator (if equipped)
To operate the generator, move the generator
toggle switch to the on position. The engine will
continue to run but no drive or platform functions
will operate.
Plug a power tool into the power to platform GFCI
outlet.
To resume machine functions, move the generator
toggle switch to the off position. All functions will
operate.
Check Engine Light
Light on and engine stopped: Tag
the machine and remove from
service.
Light on and engine still running:
Contact service personnel within 24
hours.
Machine Not Level Indicator
Light (if equipped)
Light on indicates machine is not level.
The tilt alarm will be sounding when
this light is on. Move the machine to a
firm level surface.
Machine Malfunction Indicator
Light
Light on indicates all functions have
stopped.
1 Push in and then pull out the red Emergency
Stop button.
2 Lower and retract the boom.
3 Tag the machine and remove from service.
Functions will not operate.
S-60 HC
Second Edition • Second Printing
Part No. T107112