Genie S-60 HC Operator's Manual page 23

Second Edition • Second Printing
12 Drive enable switch
To drive when the drive enable light is on, hold
the drive enable switch to either side and slowly
move the drive control handle off center. Be
aware that the machine may move in the
opposite direction that the drive and steer
controls are moved.
13 Drive enable indicator light
Light on indicates that the boom has moved just
past either non-steer wheel and drive function
has been interrupted.
14 Glow plug switch
Move the glow plug switch to either side and
hold for 3 to 5 seconds.
15 Engine idle (rpm) select switch
Move the engine idle select switch to the turtle
position for foot switch activated low idle.
Move the engine idle select switch to the rabbit
position for foot switch activated high idle.
16 Engine start switch
Move the engine start switch to either side to
start the engine.
Part No. T107112
17 Gasoline/LPG models: Fuel select switch
Move the fuel select switch to the gasoline
position to select gasoline. Move the fuel select
switch to the LPG position to select LPG.
18 Machine malfunction indicator light
Light on indicates all functions have stopped.
See the instructions in the Operating
Instructions section.
19 Platform overload indicator light
The platform overload indicator light will flash
and no functions will operate when there is more
than 1250 lbs / 567 kg in the platform.
20 Thumb rocker for boom extend/retract
Move the thumb rocker up and the
boom will retract. Move the thumb
rocker down and the boom will
extend.
21 Dual axis proportional control
handle for boom up/down and turntable rotate
left/right functions
Move the control handle up and
the boom will raise. Move the
control handle down and the
boom will lower. Move the
control handle to the right and
the turntable will rotate to the
right. Move the control
handle to the left and
the turntable will rotate
to the left.
S-60 HC
Operator's Manual
Controls
21